Joined in 2023 
82 
63 About this deal
The RF mode feels like a warm sensation on the skin, though if you’re sensitive to heat you might find it uncomfortable. I actually find it relaxing! But the DMA mode will hurt – like someone snapping rubber bands constantly on your skin. As you go from low to high mode the heat/pain will increase as well. For a week by week breakdown, I recommend reading my Stop X review as the results are very similar. As my nasolabial folds are is where I have the most noticeable sagging skin, I saw noticeable lifting and plumping at around the 8-week mark. In terms of plumpness and firmness I’m pretty much maintaining my results from before. The objective of the treatment is to gently heat the skin from within throughout the entire treatment area and then maintain this optimal temperature for a few moments before moving on to the next area. After 6 to 8 weeks, you then switch to less regular maintenance sessions. Tripollar suggests them either weekly or once every two weeks (so, 2 to 4 times per month). These sessions are much easier to fit in, and it’s one of the least effort maintenance schedules. But it’s so easy to skive off! So, you must remember to schedule the time with yourself. Saturday mornings are my favourite time. Advertised results
In the first of three articles introducing TriPollar, the first is here to explain the innovative radio-frequency technology behind their products.Therefore, it’s best to set aside a quiet and unrushed hour every few days. And if you have this time and motivation, it’s a pleasant way to pamper your skin. You can also do it whilst watching TV. T he larger nobbles on the STOP V X are much comfier than the smaller nobbles.I LIKE how the nobbles feel on my skin, especially on my scar, and weirdly around the corners of my nose. Next move the device in an upward linear motion along your jawline contour, starting right below your chin. You can switch to the blue DMA + RF mode for this step only. Repeat 10-20 times.
The latest STOP models have multi-RF. This sends Radio Frequency current into your skin at two interchanging frequencies of 1 to 1.25 MHz. The effect is to evenly heat more layers of your dermis. So, it works on even more of your collagen and elastin fibres. This means better results, but also shorter and faster treatment times. These models have 4x larger electrode nobbles on the treatment head. They also have LOW and HIGH RF levels. TIP: Sometimes that pesky beep just doesn’t come! So, if the orange light is constant and you’ve been circling a while, move on.We do not recommend use of our devices if you have an impaired immune system due to immunosuppressive medications or immunosuppressive diseases such as AIDS.
No studies were done to confirm the safety of the device during pregnancy so it’s best to stop using it, just in case. Cleanse and Prep: Clean and dry your desired treatment area, then apply a thin layer of TriPollar’s Preparation Gel. Now the STOP RF doesn’t help prevent or clear blemishes as other devices can. And since quitting microcurrent my spots and under-the-surface bumps have returned. And especially those pesky reoccurring hormonal zits. They spoil my otherwise healthy complexion so at week six I decide to treat myself to a Tripollar Geneo facial. I will continue updating this Tripollar Stop X review as time goes on, but I’m incredibly pleased at the progress so far!
Also not as important, but let’s take a minute to appreciate the tool’s aesthetics. I love the sleek design, the rose gold color, and the fact that it has its own stand to display proudly on any vanity. 10/10! My Tripollar Stop X routine On the treatment head, all models have four RF electrodes spaced 1 cm apart, with a temperature sensor in the middle. However, the STOP VX models have larger electrodes than most other STOP models. The larger electrodes are more efficient at heating your skin, and so sessions are easier and faster. Treatment heads: 4x RF electrodes with a skin temperature sensor in the middle We recommend the Tripollar Preparation Gel for best results, this have been formulated specifically for use with radiofrequency devices. Use of any other products are not recommended and we cannot guarantee results. Takes about 5-7 minutes to complete one section of my face with just RF mode, bringing the total time to 20 minutes. Add another 2-3 minutes for the RFA mode along the jawline. Initially you’ll need to use it every other day for a couple months, then reduce to 2 times a week to maintain the results. If you do not feel any heating of the skin even on the highest power level, try moving as slowly as possible without stopping the motion of the device.
DMA stands for dynamic muscle activation, which is Pollogen (Tripollar’s parent company)’s proprietary muscle toning technology. It uses electric currents that stimulate our facial muscles to contract, while simultaneously using Multi-RF. Think of it as a workout for your facial muscles! So, I use the STOP mostly 3 times per week with a total of 21 sessions over 8 weeks. Each evening session leaves my skin pinky-red and feeling invigorated, plump and smooth. But the next day it’s SUPER smooth. It takes around 4 weeks to see changes in my skin 👇. 4 to 6 weeks TriPollar technology utilises painless, focused and optimal radio-frequency energy to the dermis and to subcutaneous (situated under the skin) fat layers. Controlled energy is delivered via three or more electrodes, and is limited to the treatment area. TriPollar radio frequency is clinically and histopathologically proven to simultaneously and homogenously heat both superficial (dermal) and deep (hypodermal) layers. TriPollar products have a unique configuration of sophisticated control algorithms that causes the tissue to heat from within while keeping the epidermis safe, meaning a painless and pleasant treatment for you in comparison to other similar devices. This focused delivery results in immediate visible results. It's even safe to use TriPollar technology for treatment of fine lines and very delicate areas of the face without causing damage or pain. These include areas around the lips and around the eyes. For improved results it is recommended to undergo a course of treatments. Collagen Regeneration I hope the STOP will maintain my healthy, supple, smooth, bright and hydrated skin. I’d like to maintain my small pores too. I’m really hoping the STOP can tighten and lift my small jowls and under-chin sag, smooth my under-eye area, and perhaps reduce my forehead lines a bit more.
Our Expert View
We do not recommend use of our devices if you have any active skin condition in the treatment area including, but not limited to, sores, psoriasis, eczema, or a rash. Repeat 4 and 5 until you've completed the entire section. Now we're going to switch to linear motions. Obviously the levels from a at-home facial device won’t be as strong as what you’ll receive from a dermatologist office, but the technology itself is definitely promising. Keep reading for proof. My Tripollar Stop X review https://cdn.shopify.com/s/files/1/3097/7858/files/Visa-icon_1_100x_250b8d9b-4db2-4f08-94a4-f4b751633be9_100x.png) Finally move the device from the corner of your nose (top of your nasolabial folds) along the bottom of your cheek bones, slightly pushing upward. This is to help lift and plump the apple of your cheeks. Repeat 10-20 times.
Great Deal 
New Comment